Rhinestone sheets should only be cut using scissors or craft knife. Never attempt to place rhinestone sheets of any kind in your craft cutter. To wrap your cup or tumbler cut out the rhinestone tumbler decal using scissors. You should now have a beautiful sheet of Siser Glitter Heat Transfer Vinyl covered with sparking rhinestones.Using protective cover sheets make one final press for 5 sec. For a final press, Flip your transfer over with the rhinestones facing down and the HTV anything facing up.Let your Rhinestone and Glitter HTV transfer cool then carefully remove the hot fix tape from on top of your rhinestones.Next place the hot fix tape with rhinestones on top of the pressed Siser Glitter HTV and using a protective cover sheet over and under your project and press the rhinestones into place on the HTV with firm pressure at 320☏ for 15 sec.Allow the Siser Glitter HTV to cool off a little before peeling off the carrier sheet.Press with light/medium pressure at 310☏ for 6-8 sec. Use a crafting heat press to bond the Siser Glitter HTV to the HTV Anything material. To protect your Siser Glitter HTV while pressing your design, place a protective cover sheet on the top of and under your Sister Glitter HTV / HTV Anything.Note: These instructions are specifically for Siser Glitter Heat Transfer Vinyl. Although other types of HTV can be used to make a rhinestone tumbler, each has variations in properties and time/temp/pressure/peel settings that should be taken into account. Place Siser Glitter HTV on the shiny side of HTV Anything.Next, carefully apply hot fix tape on top of the rhinestones to transfer them from your template onto the transfer tape. As you brush your rhinestones into each hole of the template make sure they are all facing upward with the bling facing you. Using a rhinestone brush, slowly brush your rhinestones into place.Once you have cut your design in the material remove the flock from the mat and carefully stick your finished Magic Flock template on a flat table so you can brush your rhinestones into place.Following the manufactures instructions for your craft cutter load your cutting mat into the cutter and cut the TRW rhinestone template you have selected from the magic flock material.

To make a rhinestone template peel the backing off your Magic Flock template material and place the sticky side of the flock material on the cutting mat of your machine cutter.

Rhinestone template downloads free